Juniper JN0-201 덤프데모

우리 ITExamDump에서는 여러분을 위하여 정확하고 우수한 서비스를 제공하였습니다. 여러분의 고민도 덜어드릴 수 있습니다. 빨리 성공하고 빨리Juniper JN0-201인증시험을 패스하고 싶으시다면 우리 ITExamDump를 장바구니에 넣으시죠 . ITExamDump는 여러분의 아주 좋은 합습가이드가 될것입니다. ITExamDump로 여러분은 같고 싶은 인증서를 빠른시일내에 얻게될것입니다.

Juniper JN0-201인증시험이 이토록 인기가 많으니 우리ITExamDump에서는 모든 힘을 다하여 여러분이 응시에 도움을 드리겠으며 또 일년무료 업뎃서비스를 제공하며, ITExamDump 선택으로 여러분은 자신의 꿈과 더 가까워질 수 있습니다. 희망찬 내일을 위하여 ITExamDump선택은 정답입니다. ITExamDump선택함으로 당신이 바로 진정한IT인사입니다.

시험 번호/코드: JN0-201

시험 이름: Juniper (Juniper networks Certified internet associate.m(jncia-m))

수많은Juniper인증 JN0-201시험공부자료중에서ITExamDump의Juniper인증 JN0-201덤프가 가장 출중한 원인은 무엇일가요? ITExamDump의Juniper인증 JN0-201덤프는 실제시험문제의 출제방향을 연구하여 IT전문가로 되어있는 덤프제작팀이 만든 최신버전 덤프입니다. ITExamDump의Juniper인증 JN0-201덤프가 있으면 힘든Juniper인증 JN0-201시험이 쉬어져서 자격증을 제일 빠른 시간내에 취득할수 있습니다.제일 어려운 시험을 제일 간단한 방법으로 패스하는 방법은ITExamDump의Juniper인증 JN0-201덤프로 시험준비 공부를 하는것입니다.

ITExamDump는 모든 IT관련 인증시험자료를 제공할 수 있는 사이트입니다. 우리ITExamDump는 여러분들한테 최고 최신의 자료를 제공합니다. ITExamDump을 선택함으로 여러분은 이미Juniper JN0-201시험을 패스하였습니다. 우리 자료로 여러분은 충분히Juniper JN0-201를 패스할 수 있습니다. 만약 시험에서 떨어지셨다면 우리는 백프로 환불은 약속합니다. 그리고 갱신이 된 최신자료를 보내드립니다. 하지만 이런사례는 거이 없었습니다.모두 한번에 패스하였기 때문이죠. ITExamDump는 여러분이Juniper JN0-201인증시험 패스와 추후사업에 모두 도움이 되겠습니다. Pass4Tes의 선택이야말로 여러분의 현명한 선택이라고 볼수 있습니다. Pass4Tes선택으로 여러분은 시간도 절약하고 돈도 절약하는 일석이조의 득을 얻을수 있습니다. 또한 구매후 일년무료 업데이트버전을 바을수 있는 기회를 얻을수 있습니다.

JN0-201 덤프무료샘플다운로드하기: http://www.itexamdump.com/JN0-201.html

NO.1 What type of OSPF router is responsible for redistributing routes into OSPF?
A. ABR
B. ASBR
C. internal router
D. backbone router
Answer: B

Juniper   JN0-201   JN0-201   JN0-201   JN0-201

NO.2 What are two ways that a valid IBGP peering session can be configured? (Choose two.)
A. via the accept x.x/y command
B. via TCP reachable physical interface addresses
C. via remote loopbacks with the local-address command
D. via UDP with the neighbor x.x.x.x command at the group level
Answer: BC

Juniper덤프   JN0-201자격증   JN0-201자격증   JN0-201

NO.3 What are two purposes of the AS_PATH attribute? (Choose two.)
A. route selection
B. loop avoidance
C. determining equal cost paths for reachablilty
D. defining the application of other BGP attributes
Answer: AB

Juniper   JN0-201   JN0-201   JN0-201

NO.4 During OSPF adjacency formation, in what state is a router when it is negotiating to be in charge of the
database synchronization process?
A. Init
B. 2Way
C. ExStart
D. Exchange
Answer: C

Juniper   JN0-201   JN0-201   JN0-201기출문제   JN0-201

NO.5 How often are IS-IS Hello packets transmitted?
A. 3 seconds for DIS; 9 seconds for non-DIS
B. 9 seconds for DIS; 3 seconds for non-DIS
C. 10 seconds for DIS; 3 seconds for non-DIS
D. 10 seconds for all routers
Answer: A

Juniper dumps   JN0-201   JN0-201

NO.6 How do you enable interface fe-0/0/0 under the [edit protocols isis] level to form both a Level 1 and
Level 2 adjacency?
A. set interface fe-0/0/0.0
B. set interface fe-0/0/0.0 all level
C. set interface fe-0/0/0.0 level 3 enable
D. set interface fe-0/0/0.0 level 1 level 2
Answer: A

Juniper자료   JN0-201시험문제   JN0-201 pdf   JN0-201

NO.7 What are the three components of the ISO NET address? (Choose three.)
A. Area ID
B. N-selector
C. System ID
D. AS number
E. ISO number
F. MAC address
Answer: ABC

Juniper   JN0-201   JN0-201   JN0-201자격증

NO.8 A firewall filter is applied as an input filter on a transit interface. What three types of traffic will this affect?
(Chose three.)
A. inbound traffic transiting the router
B. outbound traffic transiting the router
C. traffic destined to the Routing Engine
D. traffic destined to the interface address on which the filter is applied
Answer: ACD

Juniper최신덤프   JN0-201자격증   JN0-201덤프   JN0-201시험문제

NO.9 Once the TCP connection is established, which message type initiates the BGP peering process?
A. Open
B. Active
C. Update
D. Keepalive
E. Notification
Answer: A

Juniper시험문제   JN0-201 dumps   JN0-201   JN0-201

NO.10 What is the purpose of the OSPF link-state update packet?
A. describes a change to the OSPF hello timer
B. carries one or more link-state advertisements
C. establishes and maintains neighbor relationships
D. describes the contents of the entire link-state database
Answer: B

Juniper기출문제   JN0-201   JN0-201   JN0-201

NO.11 What command would you use to view an IS-IS adjacency?
A. show iso neighbor
B. show isis neighbor
C. show iso adjacency
D. show isis adjacency
Answer: D

Juniper   JN0-201   JN0-201인증

NO.12 If all OSPF routers on a broadcast network have the same OSPF priority, what parameter is used to
determine the new BDR at the time of a DR failure?
A. area ID
B. router ID
C. loopback address
D. IP address of interface on broadcast network
Answer: B

Juniper인증   JN0-201   JN0-201인증   JN0-201자격증

NO.13 Why would you make a non-backbone area a stub or not-so-stubby area?
A. to aggregate routes learned from the ABR
B. to lower the cost of routes advertised by the ABR
C. to connect a non-contiguous area to the backbone
D. to decrease the size of the link-state database in that area
Answer: D

Juniper   JN0-201   JN0-201최신덤프   JN0-201덤프

NO.14 What is the first step in BGP route selection?
A. The local router prefers the route with the shortest AS_PATH.
B. The router first verifies that it has a route to the BGP Next Hop IP address.
C. The local router prefers the route from the peer with the lowest peer ID address.
D. The local router prefers the route learned from an EBGP peer over a route learned from an IBGP peer.
Answer: B

Juniper   JN0-201   JN0-201   JN0-201   JN0-201자료

NO.15 Three IS-IS routers on a broadcast segment have different priority values configured. Which router is
elected the DIS on that broadcast segment?
A. the router with the lowest priority
B. the router with the highest priority
C. the router with the highest System ID
D. the router with the highest IP address
Answer: B

Juniper   JN0-201기출문제   JN0-201최신덤프

NO.16 Firewall filters can be used to accept, discard, or reject packets based on _____. (Choose three.)
A. protocol type
B. MAC address
C. TCP or UDP port
D. source and destination IP address
Answer: ACD

Juniper   JN0-201덤프   JN0-201 dump   JN0-201

NO.17 By default, which command can be used to display information about packets that have been logged
with the syslog firewall filter action?
A. show log
B. show firewall
C. show log messages
D. show firewall log
Answer: C

Juniper   JN0-201자료   JN0-201 dump   JN0-201 dumps   JN0-201

NO.18 Assume that a comparable configuration is applied to your peer in AS 11 and that bi-directional TCP
reachability has been achieved. Which EBGP configuration will allow the BGP session to become
established?
A. routing-options { autonomous-system 64; } protocols { bgp { group external-peer11 { type external;
neighbor 10.0.3.6 { peer-as 11; } } }
B. routing-options { autonomous-system 11; } protocols { bgp { group external-peer1 { type external;
peer-as 11;{ neighbor 10.0.3.6; } }
C. routing-options { autonomous-system 11; } protocols { bgp { group external-peer11 { type external;
peer-as 64;{ neighbor 10.0.3.6; } group external-peer11 { type external; peer-as 64;{ neighbor
10.0.3.6; } } type external; peer-as 64;{ neighbor 10.0.3.6; } } peer-as 64;{ neighbor 10.0.3.6; } }
neighbor 10.0.3.6; } }
D. routing-options { }
E. routing-options { autonomous-system 64; }
F. routing-options { autonomous-system 64; }
G. routing-options { autonomous-system 64; } protocols {
H. routing-options { autonomous-system 64; } protocols { bgp { autonomous-system 64; } protocols { bgp
{ group external-peer101 { } protocols { bgp { group external-peer101 { peer-as 101; protocols { bgp
{ group external-peer101 { peer-as 101; neighbor 10.0.3.6; protocols { bgp { group external-peer101
{ peer-as 101; neighbor 10.0.3.6; } bgp { group external-peer101 { peer-as 101; neighbor 10.0.3.6; } }
group external-peer101 { peer-as 101; neighbor 10.0.3.6; } } peer-as 101; neighbor 10.0.3.6; } }
neighbor 10.0.3.6; } } } } }
Answer: A

Juniper자료   JN0-201   JN0-201   JN0-201   JN0-201기출문제

NO.19 Which CLI command is used to see the current OSPF link-state database?
A. show ospf database
B. show ospf neighbor
C. show protocols ospf
D. show ospf link-state
Answer: A

Juniper   JN0-201   JN0-201 dumps

NO.20 Two Level 2 routers are exchanging Hello packets with different Area IDs. What occurs between these
routers?
A. An Adjacency forms.
B. An Adjacency does not form.
C. An Adjacency forms but traffic is not forwarded.
D. No IS-IS PDUs are sent.
Answer: A

Juniper   JN0-201시험문제   JN0-201

ITExamDump 는 완전히 여러분이 인증시험 준비와 안전한 시험패스를 위한 완벽한 덤프제공 사이트입니다.우리 ITExamDump의 덤프들은 응시자에 따라 ,시험 ,시험방법에 따라 알 맞춤한 퍼펙트한 자료입니다.여러분은 ITExamDump의 알맞춤 덤프들로 아주 간단하고 편하게 인증시험을 패스할 수 있습니다.많은 it인증관연 응시자들은 우리 ITExamDump가 제공하는 문제와 답으로 되어있는 덤프로 자격증을 취득하셨습니다.우리 ITExamDump 또한 업계에서 아주 좋은 이미지를 가지고 있습니다.